Data Acquisition

The intelligent Bosch Rexroth drives and control systems are ready for Condition Monitoring, Predictive Maintenance, and Industry 4.0 right from the start. They can be flexibly adapted to the most diverse requirements and manufacturing environments. Open interfaces facilitate easy engineering and the comfortable networking of automation and IT systems.

Easy entry into sensors

HM 20
  • Sensor with thin-film measuring cell
  • Output signal: 4 ... 20 mA or 0.1 ... 10 V
  • Signal setting time (10 ... 90 %) < 1 ms
  • Accuracy class: 0.5
  • Components in contact with media are made of stainless steel
  • Repeatability < 0.05 % of preset pressure
  • Small influence of temperature on measuring accuracy Tk < 0.1 % / 10 K
IAC Multi-Ethernet Control Valves
  • Connectivity with Sercos, Multi-Ethernet
  • Maximal operating pressure: 350 bar
  • Maximal volume flow: 1,500 l/min
  • Nominal sizes: 6, 10 (directly confirmed), 16, 25, 27, 35 (pilot-controlled)
  • Safety halt via 24 V signal and feedback valve 24 V
  • 2 analog In/Out additionally configurable
Hydraulic motion control VT-HMC
  • Connectivity with Sercos, Multi-Ethernet and PROFIBUS
  • Programming according to IEC 61131-3
  • Extended temperature range: -20 °C ... +60 °C
  • Comprehensive hydraulics libraries
  • Sampling time: 0.5 ms force control/1 ms position control
  • Monitoring of actual values: 4 analog inputs, 1 linear position sensor SSI or incremental or EnDAT 2.2
IndraControl XM21/22
  • Protection class: IP20
  • On-board Sercos Master with 250 µscycle time Gigabit-Ethernet, USB, SD card slot, Diagnosis LED
  • Modular expansion options with extension and E/A modules –
  • Extended temperature range: -20 °C ... +60 °C
IndraControl FM
  • Protection class: IP65
  • 36 analog and digital E/A modules for sensors, actuators and Modbus on Board
  • Multi-protocol enabled Ethernet interface
  • Preassembled hybrid cables and/or M12 plugs
  • Power supply via hybrid cables (42 VDC) or E/A box (24 VDC)
  • Standardized PLC functionalities based on CODESYS V3